Pumping with Blister

General discussion area on penis pumping, and penis enlargement.

Moderator: bigray57

Post Reply
pumpingplums
Posts: 5
Joined: Thu Nov 19, 2020 9:33 am

Pumping with Blister

Post by pumpingplums »

:? I know what most answers will be, however here we go. I had a small blister on my glans a couple days ago it appears to be almost healed. If I place a latex finger cot over my glans do ya think I can resume "light pumping" of my package in my 3" straight tube or my 4" straight tube?
I'm usually a daily pumper and I miss the routine.
mrcando181082
Posts: 66
Joined: Mon Sep 11, 2006 5:40 am

Re: Pumping with Blister

Post by mrcando181082 »

I have done the same thing so many times I can't even remember. I clean my skin with an antiseptic wash. Dry well. Apply two coats of New Skin or another liquid bandage for skin. Let dry COMPLETELY. Apply coco butter and pump again!!! Works every time!
User avatar
PumperSoCal
Posts: 318
Joined: Thu Dec 24, 2009 4:06 pm
Location: Central Texas

Re: Pumping with Blister

Post by PumperSoCal »

Although it's not recommended you can. I've waited until 'mostly healed' to start pumping again. And by that I mean that the blister drained and the skin from the blister had come off naturally.Leaving the new skin underneath. But it also makes it super easy to refill it as well. So you just have to watch it. If it hasn't drained, you can also try draining it, but do not remove the skin from the blister. It might get slightly discolored because of the new skin underneath when you start to pump up, but that's also why you just have to be careful with it. Keep it clean and you can probably still pump as long as there isn't pain, discharge, or any of that. If it looks pissed off, then yeah, stop. Everyone responds differently so it might also just be good to feel it out.
Straight Pumper& Infuser

"I look normal on the outside, but you have no idea what lies beneath this brilliant camouflage."
pumpingplums
Posts: 5
Joined: Thu Nov 19, 2020 9:33 am

Re: Pumping with Blister

Post by pumpingplums »

Thanks for the advice! I'll give the new skin a try and take it easy....Hate blisters
bucket
Posts: 144
Joined: Wed May 16, 2012 5:16 pm

Re: Pumping with Blister

Post by bucket »

I keep an eye out for clear blisters when pumping, if I see one start I immediately get out of the tube and, using a sterile needle, pop the small blister, drain it, clean it with an alcohol wipe and get back in the tube. Watch to see it doesn't seal over again, if it does then repeat the process. If it's a blood blister though, I stop all together, they're another level.

Hopefully if your on top of things a water blister shouldn't become a blood blister.

B
Post Reply