Ball Tube size question

Talk about ball pumping, stretching, ball enlargement techniques.

Moderator: bigray57

Post Reply
shyguy_8121
Posts: 93
Joined: Sun Aug 27, 2006 3:09 am

Ball Tube size question

Post by shyguy_8121 »

Hey guys,
I have a 4" straight tube and it creates a nice effect. It feels a little uncomfortable.. If the balls are touching 3 sides..is that bad or should I get a Sun tea Jar? I like plastic because it is light and the sun tea jars that are plastic are so thin they collapse when you use them.
Questions
1. What do you recommend for a plastic jar? Opening 4" but sized 5" like STJ. Is there any cheap plastic jar online?
2. Is balls on the wall causing gains to be slow and is it not good for circulation?

Thanks,
Shyguy
cma_throw
Posts: 132
Joined: Tue Oct 23, 2018 2:15 am

Re: Ball Tube size question

Post by cma_throw »

shyguy_8121 wrote: Sat Jun 08, 2024 6:57 am Questions
1. What do you recommend for a plastic jar? Opening 4" but sized 5" like STJ. Is there any cheap plastic jar online?
2. Is balls on the wall causing gains to be slow and is it not good for circulation?

Thanks,
Shyguy
This has a 4’’ opening and will fit the pump toys seal and conversion set: https://www.walmart.com/ip/Mainstays-1- ... 5064803693

Balls on the wall isn’t bad, it just gives a different effect on your growth. Narrow tubes promote length (remember to lube well) and will make your sack longer. A wide stj promotes width and will make your sack more like a soccer ball.
shyguy_8121
Posts: 93
Joined: Sun Aug 27, 2006 3:09 am

Re: Ball Tube size question

Post by shyguy_8121 »

Thank you for the suggestions. Is that a thick wall stj that will not collapse? I got mine off Amazon and it's so thin when you vacuum it collapses. Have you bought this one?
I'm looking for a wide soccer ball effect. So STJ sounds the way to go.

Thanks,
Shyguy
cma_throw
Posts: 132
Joined: Tue Oct 23, 2018 2:15 am

Re: Ball Tube size question

Post by cma_throw »

shyguy_8121 wrote: Sun Jun 09, 2024 1:36 am Thank you for the suggestions. Is that a thick wall stj that will not collapse?
Haven’t tried it myself but it will hold up fine. This guy uses it: https://www.reddit.com/r/JarPumping/s/m1HXU5tpBN
shyguy_8121
Posts: 93
Joined: Sun Aug 27, 2006 3:09 am

Re: Ball Tube size question

Post by shyguy_8121 »

Thank you! Not all plastic STJ's are created equal. I can't wait!
User avatar
Brazilien
Posts: 336
Joined: Sat Aug 19, 2006 12:04 pm
Location: Brazil
Contact:

Re: Ball Tube size question

Post by Brazilien »

I have these two, the smaller one with an inlet of just under 4 inches and the larger one with an inlet of 5 inches. They are made of glass, thick and maintain the temperature of the warm water I put in for the session.
Attachments
dfabxa.jpg
Post Reply