Outer labia, Clitoral Hood, and penis enlargement/Beading

[HammerOfLight]

My GF and I have been playing around for awhile with saline enlargement of both The girth (godz it's long enough as it is) and texture of my penis using saline injection subdermally. We also plumped her outer labia, and clitoral hood, and niple with saline. The problem is that it wears off rather quickly, 24 hours is about the longest it's ever lasted. I began working on a few ideas for formulas using some research on the internet into cosmetic fillers used by plastic surgeons.

NOTE: The following are my experiments, so far so good, try these at your own risk. The bigest danger is improperly prepared formulas could cause an infection! I'll list the exact formula at the end of this.

I created a formula using cold saline .8% as the starting point, and dissolved some USP grade AGAR into it, while stirring with a magnetic stirring hotplate. The saline solution I made using R.O. water, and Kosher salt, should be ICE COLD so that the AGAR doesn't clump up. Allow it to stir until completly dissolvled. I added 1mg of Citric Acid USP, I then adj. the ph so that it was at aprox 7.1-7.2 using a digital PH meter (I have a mid sized lab in my apt.) The best substance I found for this was to use tetra-Sodium pyrophosphate, Apply heat and continue to stir until the solution clears (The TSPP chelates metals, momentary cloudiness will occur). Add 1ml of Propylene Glycol USP to the mix, and heat until it reches about 85 Deg. C. You may want to filter this now while hot to remove any undissolved AGAR and such. Take the filtered solution, and place it in a glass bottle with a phenolic stopper and autoclave it at 15psi for 30 minutes (presure cooker does the same), this is to sterilize it of any bacteria.

FORMULA;

250 ml cold distilled or R.O. water
2 g. kosher salt (grocerie store)
500 mg. AGAR AGAR (try e-bay, health food store,should be food grade, or microbiology grade)
1 mg. Citric Acid USP(antioxidant), (Health food stores)
Tetra-sodium pyrophosphate,TSPP USP(buffer, chelator)
1 ml. Propylene Glycol USP(veterinary supply, chemical supply, e-bay again)

stir cold water under med fast rate, and add Kosher salt,
after salt has dissolved, add AGAR AGAR, and allow to dissolve completly. Add citric acid, and allow to dissolve, then adj. ph to 7.1-7.2 with TSPP. Add Propylene Glycol, and begin to heat to 85 deg. C. Strain/filter out any solids, and autoclave the filtered/strained solution at 15 psi in a pressure cooker.)

I created a small bead under my skin of this solution while it was at 98 deg. F or so, all when well, slight stinging, barely noticeable. 12 horus later the area had swollen some to about 3 times it's inital injection size. 48 hours later the swelling was gone, never experienced any pain or itching, etc. the bead is semi hard, slightly flexible (ever poured petri dish plates using agar in a lab?) wait to see how long it takes to shrink as the body begins to decompose it (hopeing for 3 weeks or so).

Weigh your decision to use this formula well, all is fine with me so far, I am not sure how long it will take to breakdown. I will report any sideeffects, etc as they ocuur if they occur.

[itzkiller]

got pics of any of this?

[desertdog]

I've tried the normal saline solution as well. I've injected 70cc SubQ in my cock and 120cc in my bag. The main results lasted for about4 days and I could still see some residual for a little over a week. The next time, I'm going for 100cc in my cock and 180-200cc in my bag. My wife loves it and calls it her "fat baby". She loves not only the girth increase but the weight. She'll grab my sack and just heft it. My wife won't even think about it, she freaks out on needles. The only thing I found is that you need to use a small gage needle and go SLOW for the injection. I would post some results but my camera won't "talk" to my computer, but that's another story.
I tried sterile water for injection and it BURNS so no more of that.

[kalifoster]

My GF and I have been playing around for awhile with saline enlargement of both The girth (godz it's long enough as it is) and texture of my penis using saline injection subdermally. We also plumped her outer labia, and clitoral hood, and niple with saline. The problem is that it wears off rather quickly, 24 hours is about the longest it's ever lasted. I began working on a few ideas for formulas using some research on the internet into cosmetic fillers used by plastic surgeons.

NOTE: The following are my experiments, so far so good, try these at your own risk. The bigest danger is improperly prepared formulas could cause an infection! I'll list the exact formula at the end of this.

I created a formula using cold saline .8% as the starting point, and dissolved some USP grade AGAR into it, while stirring with a magnetic stirring hotplate. The saline solution I made using R.O. water, and Kosher salt, should be ICE COLD so that the AGAR doesn't clump up. Allow it to stir until completly dissolvled. I added 1mg of Citric Acid USP, I then adj. the ph so that it was at aprox 7.1-7.2 using a digital PH meter (I have a mid sized lab in my apt.) The best substance I found for this was to use tetra-Sodium pyrophosphate, Apply heat and continue to stir until the solution clears (The TSPP chelates metals, momentary cloudiness will occur). Add 1ml of Propylene Glycol USP to the mix, and heat until it reches about 85 Deg. C. You may want to filter this now while hot to remove any undissolved AGAR and such. Take the filtered solution, and place it in a glass bottle with a phenolic stopper and autoclave it at 15psi for 30 minutes (presure cooker does the same), this is to sterilize it of any bacteria.

FORMULA;

250 ml cold distilled or R.O. water
2 g. kosher salt (grocerie store)
500 mg. AGAR AGAR (try e-bay, health food store,should be food grade, or microbiology grade)
1 mg. Citric Acid USP(antioxidant), (Health food stores)
Tetra-sodium pyrophosphate,TSPP USP(buffer, chelator)
1 ml. Propylene Glycol USP(veterinary supply, chemical supply, e-bay again)

stir cold water under med fast rate, and add Kosher salt,
after salt has dissolved, add AGAR AGAR, and allow to dissolve completly. Add citric acid, and allow to dissolve, then adj. ph to 7.1-7.2 with TSPP. Add Propylene Glycol, and begin to heat to 85 deg. C. Strain/filter out any solids, and autoclave the filtered/strained solution at 15 psi in a pressure cooker.)

I created a small bead under my skin of this solution while it was at 98 deg. F or so, all when well, slight stinging, barely noticeable. 12 horus later the area had swollen some to about 3 times it's inital injection size. 48 hours later the swelling was gone, never experienced any pain or itching, etc. the bead is semi hard, slightly flexible (ever poured petri dish plates using agar in a lab?) wait to see how long it takes to shrink as the body begins to decompose it (hopeing for 3 weeks or so).

Weigh your decision to use this formula well, all is fine with me so far, I am not sure how long it will take to breakdown. I will report any sideeffects, etc as they ocuur if they occur.

[kalifoster]

I'm VERY interested in saline infustion of the breasts and nipples on females. PLEASE post some pix! Thanks, Kali[/list]

[Guest]

help!
http://spam.org/porn_clips/9486