Balls only pumping setup

[zxclobber]

Anyone here pump balls only?
I've seen a lot of full package setups, but it feels uncomfortable, and prefer my rod and balls going in the opposite direction.
Sharing my setup to hopefully find some new ideas or gear. Also interested in other things people here do to grow or exercise their balls.

Gear

Setup

After 2hours

What I found:

1. Wearing an Oxball Juicy over Oxball Neo Tall makes it easy to isolate the balls for vacuum chambers with 3inch opening. Made my own jar because prefer compactness for convenience. Other tubes that I think would worked:
- Pumptoys chambers (Use to do this. Their seals are thick result in 3inch opening)
- LA Pump 2 Stage
- Monstertube Jr (2.5” opening so might work. It’s just too long for convenience)

2. The Smart Electric Pump on Aliexpress is really useful.
- Can choose whatever pressure you want. Most other pumps I've seen have set preset pressures.
- It will automatically repump if pressure drops. If your setup leaks, the pump will automatically bring pressure back.
- It has a smart mode that releases and repumps every minute.

3. Low pressure is best, as it lets you go for long time. I find that at higher pressures the cords connecting the balls begins to swell which is really uncomfortable.

4. Lubrication between the scrotum and stretcher helps, as it softens the pinching feeling from wearing anything on the scrotom for too long.

Now only issue I have left is how to keep the scrotum relaxed and soft, to stop them from squeezing the balls and reversing the pumping efforts.
Currently using a hot small medical wheat bag to heat my tube before pumping. Hoping a Stealth graphene heat pad might be more convenient.
I also tried scrotox but that’s too expensive and the effects are too little.
Also stretching with weights for more ball room.

[TinyMe]

Good work buddy.

Using a heat pad is a good idea as it will keep both jar and balls warm and flexible.

The only drawback to this is the fact that your scrotum skin will be more relaxed, therefore allowing more fluids to easily pass through the “chamber”. Your bag and balls will get larger, making it more difficult to get back out again, but, I guess it’s not the worst problem to have!

[hptrdsguy50]

Where did you find the jar???

[zxclobber]

Where did you find the jar???

The jar is a DIY using:
- Glass jar from the local homeware/kitchenware store
- LA Pump Female Coupler
- M10x1x4mm fastener
- washer and silicone to seal the coupler to the jar

Also had to purchase a glass cutter drill bit, and youtube some videos to safely drill the hole through the jar.
Now if only I could find something like this in acrylic.

Your bag and balls will get larger, making it more difficult to get back out again, but, I guess it’s not the worst problem to have!

Getting stuck is an achievement, but lube helps.
That's why I was checking the Monstertube, but they don't look too compact.

[dhard02]

Great Ideas! I just picked up this from Dollar General. It is a bit thin-walled, and it is acrylic. I am thinking of cutting the length down some so the opening is closer to 3.5 inches, and drilling in the vacuum valve.
https://www.dollargeneral.com/p/solid-b ... 0002039133
straw dispenser $3.00.