Split Collar Ring frustration

[swordfish628]

Where can I get a set of split collar rings I bought some from extreme restraints , and I cant even get close to fitting in them ...Frustrating ...............I need to go where they have larger sizes
Thanks for the help

[nnyx]

What state are you located? There is a trick to getting in them...What is the inner diameter (measure strait across the opening).....We may need to make a trade...

[swordfish628]

I am in Pa I you check out the extreme restraints web site you can get the size I think i got the 1 inch and the 2 or 3 inch length

[pierced]

Hi Guys!

The trick I use is to slip a 40mm ID stainless ring over your balls and pull down on it, then put the two halves of the weights on, works every time for me. Watch out you don't get the narrow ID ones, I did the first time, couldn't get them around the skin. I found the cheapest was at www.bodyjewelleryshop.com a UK based piercing shop, cheap and fast postage and I live in Australia.

Regards from down under
Graeme

[princealbert00]

You can buy split collars at Grainger. They have all sizes. I too could not use the one I bought on a sex site. I use a 1 5/8 to 1 3/4. They are kinda sharp and rough but a little time with a grinder and sander they are fine.

[Pourne]

Sword I'm not trying to derail your post, but PrinceAlbert tell me about your lower piercing through your ball sack. That's plenty hot and I need to do the same thing. Tell me what to expect with the bleeding/healing.

[princealbert00]

It started out as just a regular scrotal piercing and I have stretched it to a 0ga. It bled about as much as any piercing.