forums.newart.com

Hello:
I thought I’d start this discussion here but please redirect me if it belongs elsewhere.
I have no problem pumping my nipples as they are of average size, yet my husband is interested in pumping his nipples.
Our issue is that we can’t find a tube narrow enough to capture his nipples.
The tubes we’ve found are too wide and (please no laughing) he winds up having “puffies”.
We’d prefer that his nipples get elongated.
Has anyone had any experience with this or come up with a simple solution?
Thank you,
Kate

Hi Kate,
male here. my female playmate likes to have her nipples pumped. We mainly use rubber (silicone?) cups that stay on for a quite long time. But as you mentioned, using them on my nipples I get Puffies
Having the diameter of a male nipple in mind the only proper long and narrow tube that may do its job is a - well, narrow tube. There are plenty of variants out there, made of rubber, silicone, PVC etc. You find them in DIY shops, aquaristic supply shops or on the internet.

Sorry to not have better suggestions, enjoy.

These are the narrowest ones I could quickly find.

https://www.amazon.co.uk/Bondage-Locker ... GKPB&psc=1

Thank you for the reply.
Yes, we have those and they work fine for me. We also have cylinders that require a pump to create the vacuum, again-they’re best used on me or I might consider using them on my clit- the keyword here is MIGHT.
Presently, I enjoy my nipples and clit the way they are…
Thank you for the tube suggestion as a temporary measure.
Kate

Have you tried a syringe? Cut the tip off use the plunger body.

I suggest Supple Cups. They come in like 4 different sizes and they really worked to grow my nips out. Matter of fact mine are longer and thicker then my Wifies which she loves to pull on Silcone based with a little lube they suck and sty put even under a shirt for long extended wear. Women use them that have inverted nipples so perfect for guys in my mind. Good luck!

asslicker061 wrote: ↑Fri Mar 31, 2023 10:14 pm Have you tried a syringe? Cut the tip off use the plunger body.

That's what I use. I then hotmelt glue a female quick disconnect to it.

My thanks to everyone for their support and input.
I think our best probable solution might be the smallest twist type nipple sucker and to find a way to smoothly and safely narrow the cylinder to lengthen his nipples.