Page 1 of 1
Seal/gasket fo Monster tube
Posted: Wed Nov 30, 2005 3:28 am
by VacPumpDude
Anyone had any luck finding a sheet on the correct foam material to make a new seal/gasket for their Monster tube? I will buy one if I need to. But, if I can find the material, I can keep plenty of "spares" on hand.
Thanks
Posted: Wed Nov 30, 2005 5:58 am
by xerxes
Try your local DIY or hardware store. They should have foam "tape" for draught excluding or gap sealing in various widths and thicknesses. A little experimentation should give you one which will suit
Xerxes
Posted: Thu Dec 01, 2005 4:50 am
by tomk
I looked for a similar material but was unsucessful. Just buy a new one from Monstertubes. I just bought 2 and had them in a matter of a few days.