Page 1 of 1
How do I pump my balls?
Posted: Wed Apr 20, 2005 1:55 am
by imanewpumper
I've been pumping for a little while, and want to know what I have to do to pump my balls. I can't pump everything at the same time, so how long do I leave my balls in and what technique do I use, etc?
Re: How do I pump my balls?
Posted: Wed Apr 20, 2005 8:58 am
by hornytoads
you basicly do your balls the same way you do your cock, thats the way i have always done mine. what kind of tube are you using?<br>
Re: How do I pump my balls?
Posted: Wed Apr 20, 2005 11:28 pm
by imanewpumper
You mean leave them in there for about 5 minutes at a time, rest a little, repeat for an hour?<br><br>I am using the "Big Man's Pump"...can't fit both my cock and balls in there, but I can pump my balls by themself.
Re: How do I pump my balls?
Posted: Thu Apr 21, 2005 9:26 am
by hornytoads
yes thats it basically, but you need to leave them in for longer than that. i would try 15 mins as long as there is no discomfort, then gradually go for longer periods of time, but use low pressure for best results<br>
Re: How do I pump my balls?
Posted: Thu Apr 21, 2005 9:03 pm
by BullRon
If you're really interested in "Ball-Pumping", then you WILL need a tube with a diameter at least bigger than 3inches. Ballpumping works like the old gold fish theory: A gold fish will grow as big as the pond that it lives in. The bigger the pond, the bigger the gold fish. Same thing applies for the balls and it's tube. How can one expect the balls to expand for size if the tube doesn't provide the space for expansion? Make sence? I sure hope so

<br> I remember back in 1990. I out grew the biggest tube that my local leather bar sold (3 inch dia.) so I had to contact Pumpworks ( S.F. Calif.) to order a special size of 4 and a 1/4 in. Nowadays, it's a pretty common size for ball pumping. I'm particular to my 2 stager cause it helps provent the lower stomach from being sucked in.<br> During my average 45 minute to a hour pump session, I take a break every 10 minutes by pulling off the tube, message the balls just alittle, re-lube (if I have to) and then back in the tube. The break only last for about 90 seconds. I NEVER use excessive pressure and heat (heating pad wrapped around the tube). Listen to your body. There may be "alittle discomfort" at the beginning of your pump session but it should NEVER be painful!!! Use moderate pressure and heat during your session. This will (most times) give you a nice, natural big balls appearence instead of the big, purple, bloated scrotum look which I have seen so much of. But I guess it's all about one's goal with the tube.<br> So, new ball pumping bud, hope this has shed alittle light for ya. Now please keep in mind this is only what has worked best for me. Good luck, Ronny (Ball pumping since 1989)
Re: How do I pump my balls?
Posted: Fri Apr 22, 2005 12:03 am
by teddy
Hey Ronny, I appreciated that good advice too. Thanks.
Re: How do I pump my balls?
Posted: Sat Apr 23, 2005 1:27 am
by imanewpumper
Thanks for the advice. How much would a new tube cost? Also, mine is 2.5" in diameter I believe. It is too big for my cock right now, I think. It was enough buying this pump, but I don't know where I can get a cheaper cylinder that is good. I need a skinnier one, but still long...where can I get some?