Page 5 of 6
Re: Kiwipumper kp2's pumping thread.
Posted: Tue Apr 11, 2023 5:04 am
by Brazilien
If you spend two hours in the pineapple, you'll like it... But you need to make an epoxy ring on the edge to make it more comfortable... Like mine.
Re: Kiwipumper kp2's pumping thread.
Posted: Tue Apr 11, 2023 7:12 am
by kp2
Brazilien wrote: ↑Tue Apr 11, 2023 5:04 am
If you spend two hours in the pineapple, you'll like it... But you need to make an epoxy ring on the edge to make it more comfortable... Like mine.
Yes, I do! I'll be developing one for it over the next couple of weeks. Interestingly, the size of the entrance meant that if I pumped to a firm, very useful pressure I could sense it impinge on an artery in my left leg groin area. I decided to ease off to where I couldn't sense that... I think/hope a good ring will help reduce that impact and let me go to a higher pressure.
Re: Kiwipumper kp2's pumping thread.
Posted: Tue Apr 11, 2023 8:04 pm
by Brazilien
I think it's better not to press too hard. use good pressure but without causing discomfort or pain. extend the time inside the tube.
I do the pressure and keep it for 60 minutes. 10 minute break and repeat again another 60 minutes. In two hours I'm already stuck in that jar and if I want I can go for the biggest one.
Re: Kiwipumper kp2's pumping thread.
Posted: Wed Apr 26, 2023 11:15 am
by kp2
I can't get the balls any bigger in this jar.
This is the result of:
2 lots of 45m warm water pumping in this jar;
1 hour break
1h20 in the pineapple STJ with warm water (pumped while on a work zoom call). Took a bit of effort to get out of that...
Then this 40 mins. Wanted to keep cock out for entirely balls only, but that proved a bit painful, so it eventually went in, but I estimate it's less than 20% of the meat in the jar.
.... Need a bigger jar with a wider mouth!
Re: Kiwipumper kp2's pumping thread.
Posted: Tue Oct 24, 2023 8:00 am
by kp2
Ok - update.
Using the pineapple, I think I've reached the biggest I can without getting stuck!
For scale, the pineapple's opening inner circumference is 11" (3.6" diameter) and the outside circumference of the main chamber is 22.75" (approx 7" internal diameter). My balls got to 18" - and that took ~20+ minutes to get out... doing the maths it's no wonder it was a (sweat inducing) struggle - even with a pump steadily increasing the pressure inside the jar! Even though I could, it's probably unwise to go bigger in this jar...
Enjoy!
Re: Kiwipumper kp2's pumping thread.
Posted: Tue Oct 24, 2023 3:08 pm
by TinyMe
It’s great how you don’t really get any skin discolouration, great pumping!
(You need a bigger jar

)
Re: Kiwipumper kp2's pumping thread.
Posted: Wed Oct 25, 2023 10:36 am
by kp2
TinyMe wrote: ↑Tue Oct 24, 2023 3:08 pm
It’s great how you don’t really get any skin discolouration, great pumping!
(You need a bigger jar

)
Thanks. That may be down to using magnesium Epsom salts in the water, water temp at the start of each set is 45-47°C, or pumping only once or twice a week, or not too high pressures.... And I really focus of keeping the jar lip snug into the pubis-cock point and really pulling in the sac lower down (I personally dislike pubic mound in my pumping: it's all about the cock and the balls - nothing else).
(And yes, I do!

)
Re: Kiwipumper kp2's pumping thread.
Posted: Wed Jun 19, 2024 6:51 am
by kp2
Today's pumping is day 3 of 3 in a row - first 90 mins....
Re: Kiwipumper kp2's pumping thread.
Posted: Wed Jun 19, 2024 7:00 am
by kp2
Session 1 done. A break, then S2....
Re: Kiwipumper kp2's pumping thread.
Posted: Fri Jun 21, 2024 11:51 am
by kp2
This is my view when out n about.
https://www.reddit.com/r/ballpumping/co ... are_button
Do you reckon anyone noticed?
Re: Kiwipumper kp2's pumping thread.
Posted: Thu Feb 27, 2025 12:45 pm
by kp2
And today....
Re: Kiwipumper kp2's pumping thread.
Posted: Sun Mar 23, 2025 5:53 am
by greenie
Tasty looking man meat so touchable
Re: Kiwipumper kp2's pumping thread.
Posted: Sun Mar 23, 2025 7:15 am
by lonepmpr
Great results
Re: Kiwipumper kp2's pumping thread.
Posted: Sun Mar 23, 2025 8:14 am
by GrizzDaddy
kp2 wrote: ↑Thu Feb 27, 2025 12:45 pmAnd today....
Wow! Incredible pump!
Re: Kiwipumper kp2's pumping thread.
Posted: Mon May 12, 2025 2:16 am
by hippy007
Nice pump lots of room in there for saline.