forums.newart.com

How do you even pump in.. vase? Did you drill hole to plug the pump or how? Never knew it :X

You just slide the tubing into the opening along side your balls..

How does that make a seal though? I've never been able to get more than a tiny amount of vacuum doing that, even with a very thin tube.

Are you using liberal amounts of lube?
Maybe you are sucking and not inhaling.

I'll have to try being more liberal with the lube I guess

In an awkward position where the opening of the jar I have is too wide to make a great seal using only lube, but too narrow to use with my tube seal... Don't think any amount of lube will help!

Love my vase also!

soundsgreat87 wrote: ↑Fri May 12, 2017 6:43 am In an awkward position where the opening of the jar I have is too wide to make a great seal using only lube, but too narrow to use with my tube seal... Don't think any amount of lube will help!

Don't despair.
Get a vessel with a smaller opening and after you get some size you will seal better in the first tube.

To pump in a vase, there's 2 ways I create vacuum. First, lube your C & B's well, then put one end of a 3 foot length of 1/4 inch (or less) plastic tubing into the vase (or jar). Keep the other end in your mouth. Slide your C & B's into the vase, then suck on the tubing, creating a vacuum. To increase pressure, make little baby sucks. Once you have enough vacuum built up, slip the tubing out of the vase.

Insert the tubing alongside your balls to relieve pressure or remove the vase.

I also use a hand held brass suction pump, used for sucking oil & water from motors, commonly available in auto parts stores. I attached 1/4 inch tubing & a Colder quick disconnect check valve for Bullmaster use, but also added a small tube for vase/jar use. It provides higher vacuum.

To remove pumped C & B's from the vase, leave the tube in the vase, stand up & let gravity slowly lower the vase. Don't rush it. Warmth helps.

My vase openings vary from 3 1/2 to 4 inch diameter.

I like vases because of the tapered opening. I can leave it on for a long time, varying vacuum in comfort. I wish Bullmaster incorporated the taper on their tubes - then you wouldn't need the silicone cushion.

x

x

Love it looks great

Outside pumping

Well, I put on my Bullmaster today. It was warm out, the little tub had warm solar-heated water in it & I pumped. Yep, the vase isn't my favorite anymore. No anxiety over glass, higher vacuum, more comfort, I just get bigger & packed it. So, I ordered a Magnum.

Filling the Bullmaster & hiding Chance unflared.