forums.newart.com

bignlow wrote: ↑Wed Jun 05, 2024 12:44 am That's looking like good length Tiny. day off and go again. Good soak in the bath tonight and they should drop nicely.

BnL

Ah, if only I had a bath…

Looking Great! I really appreciate your posts and all of the insight that comes from the conversation. Can you possibly share the eBay link for that new tube?

paul_frisco_123 wrote: ↑Fri Jun 07, 2024 12:44 am Looking Great! I really appreciate your posts and all of the insight that comes from the conversation. Can you possibly share the eBay link for that new tube?

Thanks, of course, no problem

https://www.ebay.co.uk/itm/404813747331 ... media=COPY

Having a lazy morning in bed, coz you know, it’s Monday and I can…

Staying in the tube with the electric pump keeping the vac at 11kpa (3.25inHg)

Really hoping to get this gap at the end to close up, but it’s been a long while so far, and I wanted the cock to get something too. We’ll keep it warm and see how we get on.

If you sit up from that position it will pull the cock back and give the balls more room to expand so they can pack the tube. Once packed your stretch
will accelerate. Looking good though and getting there.

BnL

bignlow wrote: ↑Mon Jun 10, 2024 9:25 pm If you sit up from that position it will pull the cock back and give the balls more room to expand so they can pack the tube. Once packed your stretch
will accelerate. Looking good though and getting there.

BnL

I know I just wanted the cock to get a little something beforehand.

(So it doesn’t get jealous! )

I once got to 17.5cm in the 2.75” (have you still got it Bignlow?) but getting past 16.5cm in this 3.00” is proving hard going!

It would be good to get to 18cm in this one day, but the taint is putting up some resistance…

2.75 is near as damn it 70mm. I have one of mine at that measurement, don't recall getting one off you at that.

BnL

bignlow wrote: ↑Thu Jun 13, 2024 6:53 pm 2.75 is near as damn it 70mm. I have one of mine at that measurement, don't recall getting one off you at that.

BnL

I sent it up to you to see if you could fix it

Ah, that one. that's a 2 1/2 tapering down to 2 1/4, After you got into jars i expected you wouldn't need this but it can still be fixed if you need it.

BnL

bignlow wrote: ↑Thu Jun 13, 2024 7:15 pm Ah, that one. that's a 2 1/2 tapering down to 2 1/4, After you got into jars i expected you wouldn't need this but it can still be fixed if you need it.

BnL

I thought it was a straight 2.75” ?

Anyways, no, keep it or chuck it, it only cost £7.99 on eBay!

It's 2.75 give or take at the entry but that's on the outside. I must admit the first tube i used was 2 1/4 tapering down. didn't take long to fill that, hence i started making bigger ones.
I have to say, you look to be doing fine in that bigger one, you probably wouldn't get in this one now. !!

BnL

Cheers Big!

I’m beginning to understand what you mean about length now. There’s something pleasing about seeing the balls get further down the leg!

Perhaps I should (re)invest in some ball weights to help keep them down there…

Just make sure you aren't pulling too much abdomen in. The more you keep out, the more the balls get pumped and stretched.
Plan should be to get them down to the bottom of that tube then expand them in your bigger jars.
Looking good.

BnL

bignlow wrote: ↑Thu Jun 20, 2024 1:21 am Just make sure you aren't pulling too much abdomen in. The more you keep out, the more the balls get pumped and stretched.
Plan should be to get them down to the bottom of that tube then expand them in your bigger jars.
Looking good.

BnL

It might take a (very long) while to get down there!