Summer's here!

[TinyMe]

Weights !
My Chain Gangs won't fit - Off to the 3d-print cave, BallMan !
For ball weights that are too small, make a pair of plastic shims that fit between the two halves. Might need a longer set screw....
Spacers should match cross-section of weight.
All these parts might be finicky putting on.
Seems a common problem especially after pumping. It's hard to order a size that fit.
Could be another ChainGang offering.
PXL_20240301_001129438.jpg
Shim.jpg

Good work

[bajapumper]

Been in BM Magnum til noon today. Heating pad, varying pressure.
Once this thing's about full, it's on for a while.
Been puttering around the house & out back.
Mechanical car issues postponed hot springs trip, but I'm still pumped for it !
PXL_20231111_205738973[6171].jpg

What seal/cusion are you using with th BM Magnum?

[Pumping Now]

Home made, foam & fiberglass. Details on this thread, do some searching or browsing.
I've made some with 3d printer, too.
Comfortable for hours.