12mm PA

Leontes · Post by **Leontes** » Fri Sep 14, 2007 7:28 am

I have a 10mm PA at present but would very much like to upsize to 12mm. I would be glad to hear from anyone that has experience of this size concerning how they find it. I also have a problem that my piss slit will need stretching a fair amount in order to accommodate the larger size ring. Has anyone any suggestions about how to do this.

pierced · Post by **pierced** » Sat Sep 22, 2007 4:57 pm

Hi! I went from a 3mm to a 10mm in 3 months. Every time I pulled out my penis, for a leak etc, shower, I would slap it 10 times on my left thigh, then 10 times on my right thigh. If I seen some light/gap showing, I would insert the next size up with some vaseline, then start again.

TWFJR · Post by **TWFJR** » Sat Sep 29, 2007 3:37 am

I too find it difficult to stretch my urethra. My PA jewelry is 3/8's inch in diameter. That converts to approximately 9.2 mm or a 00 gauge. What I need is an expanding insert to gain the stretch I desire. I am wanting to enlarge the urethra to 3/4's of an inch and wear a 1/2 inch circular barbell. Stretching needs to be done slowly or one risks tearing which leads to scar tissue. Scar tissue does not stretch as easily. Tearing is painful and if the stretching is left in place after tearing it continues to tear causing continued pain and the nerves are affected all the way down one's legs to the feet. Very uncomfortable. This is my experience. So, I have a double problem at continued stretching. I must now deal with scar tissue.