Implants and piercings
Moderator: bigray57
-
- Posts: 5
- Joined: Fri Mar 04, 2005 9:41 pm
-
- Posts: 102
- Joined: Fri Aug 09, 2002 10:39 pm
- Location: U.S.
I like the beads can you tell me a little about the beads? Where did you have them done, what size are they, how long did they take to fully heal. do you have any problems with them moving, can you pump with them? I have been intrested in getting some done but have not found a shop willing to do them. Most all say they quit due to so many problems with them. 

-
- Posts: 57
- Joined: Sat Jun 22, 2002 6:03 am
- Location: Gold Coast Australia
Hi! I can answer your question. Originaly I had a circle of implanted 10mm diameter beads flattened on the bottom. I did this because I read it stopped them moving-false, mine rotate and I was always turning them back. I had 4 inserted on the top. I had all removed except for one underneath near my PA and one on top, because of irritation. All my implants were done by a GP (doctor) who is a qualified instructor in piercing implants in Sydney Australia.
Healing time was very quick 10 days and I was 59 at the time. My top implant causes rubbing when pumping and I might remove this as well. My wife loves them.
Regards from down under
Healing time was very quick 10 days and I was 59 at the time. My top implant causes rubbing when pumping and I might remove this as well. My wife loves them.
Regards from down under
-
- Posts: 102
- Joined: Fri Aug 09, 2002 10:39 pm
- Location: U.S.
Thanks for the answer. So over all are saying that the beads are not such a god idea. I love the look and was thinking of getting a few done. I have talked with a piercer that had it done and removed due to migration of the beads. Basicaly he said if you had tight skin they tend to stay in place. Pumping has lead to very lose skin around my shaft which makes me belive I wount have much luck 

-
- Posts: 2
- Joined: Wed Mar 14, 2007 7:22 am
piercing and implant
I think the idea is good but thr pic is very bad
-
- Posts: 244
- Joined: Tue Jul 11, 2006 11:18 pm