newbie pumpn into 2 inch tube

[lmsmfi]

only been doing this for 3 days, i pump my cock for 30 mins, then move to balls. they are 4.5 in tube at 5hg and getting longer as they are in tube, what's interesting is that my cock stays nice and fat while i pump balls, usually it will shrink. is this normal? 2 inches is just too small, going to move up
First pic is after 40 mins ball pumping and a good hour after cock pumpn. Cock still pretty fat, balls, well I have a ways to go.

[lmsmfi]

Here's what I have noticed pumpn with heat pad. Before when I pumped my cock in the tube, I didn't use heat. Pump from 7-10hg for about 30-45 minutes with 10 second rests every 3 minutes. I would rarely get a donut. Now with the heat my cock gets fatter and a tad longer in the tube with a nice donut. The weird thing in that hours later I will have a nice donut and if I stroke my cock and get hard, it's like my cock was just pulled out of the tube. Nice and fat. Is that because of the heat or me also pumping my balls after my cock?
Thx

[Toledopumper]

Great start

[mikej]

Looking great and seems you doing the right thing. Gonna try heat pad and pump alone balls.

Also try your routine and hope I get close to what I see

[lmsmfi]

Thx. I'm able to stretch balls in tube now to almost 5 inches, but I think that's it. Will move to another tube, globe, whatever. I'm also able to pump my cock to 7.5 inches and fill half the 2-inch tube. I don't think my cock will get any longer in the tube which is fine. It will get fatter if I want, but don't want big donuts. I will say this, if I get a nice pump in and pull out of tube, it's a turn on stroking a nice fat cock.

[Polarbear65]

Yer doin great buddy, awesome job!

[blazinballa]

I got a few options for sale 2.5" size.. check my posts

[lmsmfi]

Had a good 30-minute pump this am and was able to get a 5.5 stretch.

[Pumping Now]

Gives me the idea - join 2 straight tubes in a 'V' .. 2" for cock, 3 1/2" for balls. Might avoid the problem of getting out.

[lmsmfi]

That would probably work, it would be the part where the V connects that would be difficult. Then you have to figure out how the main opening would fit against the body and seal. When i was done with that mini session, it took a bit to pull them out. Going to buy some ball stretchers, not sure if i should go with the weighted ones or start off with silicone..

[bigtitlover]

Like how you pump and stretch the balls .
Like ballpumping too , especially cock and balls together in a jar

[lmsmfi]

I just bought an 8-inch globe to pump both cock and balls at same time, but I don't want to get a donut, etc. In other words, I want bigger balls for sure and a bigger cock, but I don't want a big donut. Is that possible with a globe, or do i need to get a 3- or 3.5-inch tube and pump just my balls into that?

[lmsmfi]

I made it to 6" this am which is unreal as I didn't think I would get past 4. Even though I'm not pumpn for big balls, it was hard getting them out of this skinny tube. Time to pump the cock as he's getting jealous, I think. lol.

[lmsmfi]

7 3/8's, shooting for 7.5 this am

[Davefrenzy]

I just bought an 8-inch globe to pump both cock and balls at same time, but I don't want to get a donut, etc. In other words, I want bigger balls for sure and a bigger cock, but I don't want a big donut. Is that possible with a globe, or do i need to get a 3- or 3.5-inch tube and pump just my balls into that?

I have been pumping in my globe for a while now and find my cock seems to swell up much more evenly than when I pump in a tube. It’s also so much more comfortable to pump in the globe as the whole package has plenty of room to expand.

I have somewhat successfully pumped balls only in a 2-1/2” for short periods of time but seems to get uncomfortable quite quickly as the balls expand. I also have a 3.7” tube and have tried to pump balls only but the tube always wants to pull my cock into it.