I like this 60mm weight. It feels heavy enough and it grabs the whole thing, but I can’t close both ends.
I’m making a bit of a progress, as not too long ago I wasn’t able to close it at all. I wish I could close it and just wear the for a day.
Is it possible to close it or I need to stretch the skin some more? I thought maybe I’ll try longer screws that would allow a bit of space between the two parts.
New favorite weights …
Moderator: bigray57
- TinyMe
- Posts: 2846
- Joined: Tue Feb 19, 2019 12:11 am
- Location: Hampshire
Re: New favorite weights …
Sometimes, you’ve just gotta start with less weight and build up.
Two smaller split rings and a bit of lube (or soap if you’re in the shower) will open up nicely for a third, fourth etc, once the balls are used to it and have a bit a a stretch going on
Two smaller split rings and a bit of lube (or soap if you’re in the shower) will open up nicely for a third, fourth etc, once the balls are used to it and have a bit a a stretch going on
Oh to have even an average sized cock….
-
- Posts: 33
- Joined: Sun Jul 09, 2023 9:09 am
Re: New favorite weights …
Thanks.
Yes, that’s what I’m doing. I use 3 smaller ones, but all 3 stocked up are a bit smaller than this single one, so it makes sense to add a fourth one before trying this.
I’ll do that.
Yes, that’s what I’m doing. I use 3 smaller ones, but all 3 stocked up are a bit smaller than this single one, so it makes sense to add a fourth one before trying this.
I’ll do that.
-
- Posts: 23
- Joined: Wed Sep 27, 2023 12:33 pm
Re: New favorite weights …
Better start with less weight and a different design. such an unclosed ring can injure the skin, and it can be unpleasant to wear such an “unclosed” ring. Better wear smaller rings, and sometimes pull your testicles down from your body. you need to stretch your skin. Here is a forum where it is very well described how to retract the testicles with your hands https://www.secretleather.com/jarod-joh ... some-links . This is a necessary element of stretching.
-
- Posts: 2218
- Joined: Wed Apr 23, 2008 6:51 am
Re: New favorite weights …
Have the same closure issue at times. I set the pin side reach down around my balls give a tug and twist till both halves meet with no pinch. Tighten the screw and go.
-
- Posts: 33
- Joined: Sun Jul 09, 2023 9:09 am
Re: New favorite weights
I tried but I can’t do it. The more I try the harder I get and then it’s impossible to close it. Otherwise, I can almost close it. But still need about half a cm. Longer screws would work, and the ring wouldn’t have to be fully closed.
I use these three rings with no problem. Actually they are a bit loose. At times they come off while I’m wearing them. I only wear them in the house.
I use these three rings with no problem. Actually they are a bit loose. At times they come off while I’m wearing them. I only wear them in the house.
-
- Posts: 23
- Joined: Wed Sep 27, 2023 12:33 pm
Re: New favorite weights
Try putting on a wide rubber ring with a smaller diameter, and put steel rings above it. The rubber ring will prevent the eggs from slipping out, and the steel rings will not fall off it. when I started, that's what I did.STRETCH2 wrote: ↑Sat Oct 28, 2023 11:45 pm I tried but I can’t do it. The more I try the harder I get and then it’s impossible to close it. Otherwise, I can almost close it. But still need about half a cm. Longer screws would work, and the ring wouldn’t have to be fully closed.
I use these three rings with no problem. Actually they are a bit loose. At times they come off while I’m wearing them. I only wear them in the house.
- Pumping Now
- Posts: 1174
- Joined: Thu Jul 21, 2016 5:25 am
Re: New favorite weights …
Since the idea of weights is to stretch balls down, some springy device pushing up & down could work, with half the force down & the other half up. That'd remove half the pressure on the top of your balls.
Options I can think of -
Spring with cushions, (you'd have to stretch it out & 'thread' it onto your ball sac)
Inflatable tube, (slip over balls & inflate, pushing up & down)
Compressible foam, (like pipe insulation)
I got some weights but impossible to put on after pumping...
Options I can think of -
Spring with cushions, (you'd have to stretch it out & 'thread' it onto your ball sac)
Inflatable tube, (slip over balls & inflate, pushing up & down)
Compressible foam, (like pipe insulation)
I got some weights but impossible to put on after pumping...
Balls flopping free like a bull. To my knees, and beyond!
-
- Posts: 33
- Joined: Sun Jul 09, 2023 9:09 am
Re: New favorite weights …
I got a dick pump that I use for my balls too. It stretches them nicely. I’ll try to use the rubber ring from the pump and slide it over my balls. Then use the rings on top of that. The reason I haven’t done that yet is because I thought that might cut off blood circulation.
I’ll see how it goes and if it’s comfortable I will wear it for a few hours.
I’ll see how it goes and if it’s comfortable I will wear it for a few hours.
- bignlow
- Posts: 2864
- Joined: Wed Jan 27, 2010 7:30 pm
- Location: Rochdale nr Manchester UK
Re: New favorite weights …
You could try a super stretchy silicone ring. Available from Secret leather in the UK and i assume the Chain gang in the US would have them too, Just takes the hardness of the rings off the balls and is a bigger girth to the ring that should spread the load.
BnL
BnL
-
- Posts: 33
- Joined: Sun Jul 09, 2023 9:09 am