What is a good heavy duty hand pump?
Posted: Thu Jun 15, 2017 5:19 am
What is a good manual hand pump since my replacement pump that I brought the handle that you use to pump cracked into pieces :mrgreen 
forums.newart.com
Newart - pumping forums
https://forums.newart.com/phpbb/
What is a good heavy duty hand pump?
Page 1 of 1
Re: What is a good heavy duty hand pump?
Posted: Thu Jun 15, 2017 7:43 am
harbour frieght brake vacuum kit. 29.99 less on sale
Re: What is a good heavy duty hand pump?
Posted: Fri Jun 16, 2017 5:42 am
Have you tried just using your mouth?
I had a pump from Harbour Freight but it was a dry pump only.
Didnt like it.
the gauge was handy as a point of reference but i dont know how accurate it was.
I had a pump from Harbour Freight but it was a dry pump only.
Didnt like it.
the gauge was handy as a point of reference but i dont know how accurate it was.
Re: What is a good heavy duty hand pump?
Posted: Sat Jun 17, 2017 9:24 pm
What is a good technique on trying to pump you balls and cock with you mouth, I can't even get the technique down and how do you keep the air from coming out?
Re: What is a good heavy duty hand pump?
Posted: Mon Jun 19, 2017 8:24 pm
BUMP!!!
Re: What is a good heavy duty hand pump?
Posted: Mon Jun 19, 2017 9:28 pm
--keeping the air from coming out.
Make sure the tube fits. I found if its too big its harder to seal. This happens to me when I take too much time off.
Shave. bare skin seals better.
Use a good lubricant. Pipefitter suggested hair conditioner and it has worked great for me.
How are you connecting the tube to the jar? is it a STJ?
Some guys just slide the tube in along with everything else. I havent had success doing this.
I took a STJ and stuck the tube in the valve hole and sealed it with Gorilla Glue.
The pressure does not stay at the level where I start but every 5 min I readjust the pressure.
Also it falls and give a natural break and a rise and fall in pressure.
Make sure the tube fits. I found if its too big its harder to seal. This happens to me when I take too much time off.
Shave. bare skin seals better.
Use a good lubricant. Pipefitter suggested hair conditioner and it has worked great for me.
How are you connecting the tube to the jar? is it a STJ?
Some guys just slide the tube in along with everything else. I havent had success doing this.
I took a STJ and stuck the tube in the valve hole and sealed it with Gorilla Glue.
The pressure does not stay at the level where I start but every 5 min I readjust the pressure.
Also it falls and give a natural break and a rise and fall in pressure.
Re: What is a good heavy duty hand pump?
Posted: Mon Jun 19, 2017 10:14 pm
I have a monster tube, and a bull master magnum tube.
The tube that I have connects like another tube with the male adapter ends
The tube that I have connects like another tube with the male adapter ends
Re: What is a good heavy duty hand pump?
Posted: Thu Jun 22, 2017 12:08 am
BUMP BUMP!!!!!!
Re: What is a good heavy duty hand pump?
Posted: Thu Jun 22, 2017 1:23 am
1) Suck on the other end of that adapter using lung/diaphragm power.
2) to keep the air from returning back into the tube place the tip of your tongue over the opening.
3) release the connector
4) Mouth suction makes a higher vacuum than lung power.
5) enjoy!
Re: What is a good heavy duty hand pump?
Posted: Wed Jun 28, 2017 3:37 am
Mityvac makes great pumps, they're a bit expensive but are accurate and tough.
Plastic version is cheaper:
https://www.amazon.ca/Mityvac-MV8255-Se ... 19&sr=1-13
but more fragile, I dropped mine once too often and broke the handle.
I replaced it with their metal one and it's great if a bit noisy:
https://www.amazon.ca/Mityvac-MITMV8500 ... 019&sr=1-4
It does vacuum and pressure and will dent the floor rather than breaking
Cheers!
Plastic version is cheaper:
https://www.amazon.ca/Mityvac-MV8255-Se ... 19&sr=1-13
but more fragile, I dropped mine once too often and broke the handle.
I replaced it with their metal one and it's great if a bit noisy:
https://www.amazon.ca/Mityvac-MITMV8500 ... 019&sr=1-4
It does vacuum and pressure and will dent the floor rather than breaking
Cheers!
Re: What is a good heavy duty hand pump?
Posted: Wed Jun 28, 2017 3:47 am
The Harbor freight hand pump is around $20 made of brass and uses the same accurate gauge. Just sayin'.
Actually the mityvac does have a pretty cool steampunk look to it....
Actually the mityvac does have a pretty cool steampunk look to it....