Cracked 2 stage - how to fix?

Talk about ball pumping, stretching, ball enlargement techniques.

Moderator: bigray57

Post Reply
Marcus20
Posts: 156
Joined: Thu Jun 25, 2015 6:31 am
Location: Illinois

Cracked 2 stage - how to fix?

Post by Marcus20 »

Hey everyone, I have a 2 stage cylinder it's a really basic one but there is a crack in the acrylic where it meets what I am assuming to be plastic. Is there some sort of epoxy I should use?
Willing to provide pics if needed.
pumper_123
Posts: 5
Joined: Sun Sep 04, 2016 2:01 am

Re: Cracked 2 stage - how to fix?

Post by pumper_123 »

I would recommend to do the repair as shown in the sketch. Note that this is just a suggestion. I'm not responsible for any mistakes you'll possibly make during the repair or if the repair attempt is not successful. If you grind acrylic glas, especially with an electric grinder, or use acrylic glue, always wear eyeprotection!
Repair.png


I hope i could help you. Good luck!!!
5Lsal
Posts: 271
Joined: Mon Dec 21, 2015 11:19 am

Re: Cracked 2 stage - how to fix?

Post by 5Lsal »

Depending on how bad the crack is, you can use CA glue to fill it.
Spread a small layer of this:
https://www.amazon.com/Filling-Glue-Bob ... B001AYGJVY
on the crack then use light vacuum for a few seconds to pull it into the crack.
Let it set for 20 minutes, repeat if there is still air getting in.

Cheers!
Marcus20
Posts: 156
Joined: Thu Jun 25, 2015 6:31 am
Location: Illinois

Re: Cracked 2 stage - how to fix?

Post by Marcus20 »

Thank you for the help guys! I went to my local Home Depot, and bought a sandpaper wedge as well as a stick of epoxy putty. It makes the cylinder look horrible, but if it keeps a vacuum I am not going to complain.
Post Reply