I have this idea for a way to use a STJ and silicone ring to just pump balls.
When i try to pump balls only my whole package gets pulled in.
Pumping the whole package is great and I love it and I am just trying
to find a way to isolate balls.
The only thing i can find to do this is a narrow tube that pulls one direction.
I use a STJ with a silicone ring then move to a Monster Sr. ( i would have rather had the junior but this was too goodof a deal to pass up.)
When i get above 15 inches it is work to get out of the ring. At 16 inches i was stuck inside the jar for at least half an hour.
With this in mind... the reason for this is to pump balls only using a smaller hole that is divided in half.
Attached are photos of what I am engineering right now.
These are the templates for what I plan to do when my company leaves.
one pic is all 4 pieces
the next is a pic with two of the pieces assembled
last pic is all 4 pieces assembled.
This is just a paper design.
In terms of measurements:
The opening of the silicone ring gasket is about 2.5 inches.... 6.3 cm
I found a tube i like that is 2 inches across..... 5 cm
That's not a big difference at all but for me it is the different between being sucked in and not being sucked in.
Before I go ahead and transfer these plans onto 3/8 in thick plastic/silicone board....
Does anyone have any thoughts on the diameter of the hole?
or/and
Any other issues i should take into consideration as i continue to refine the mock up?
You can add thoughts in this post or message me.
Thanks Men!
Pump huge!
Ideas for Ball only pumper
Moderator: bigray57
-
- Posts: 891
- Joined: Fri May 06, 2016 7:07 am
- Doxen
- Posts: 51
- Joined: Thu Jun 04, 2015 2:45 am
- Location: Finland, Helsinki
Re: Ideas for Ball only pumper
Not sure if the measurements are right, but I can see this working well for separating balls for pumping
http://shop.oxballs.com/JUICY-DUO-Pumpe ... X-1349.htm
My regular juicy ring is comfy for pumping my whole package at least
http://shop.oxballs.com/JUICY-DUO-Pumpe ... X-1349.htm
My regular juicy ring is comfy for pumping my whole package at least
-
- Posts: 891
- Joined: Fri May 06, 2016 7:07 am
Re: Ideas for Ball only pumper
Thanks for the info.
With what is on this link you can pump either or both? Is that right?
I am trying to make something that comes apart to make it easier to get off.
Kind of a similar concept as the monster jars with hinges.t
With what is on this link you can pump either or both? Is that right?
I am trying to make something that comes apart to make it easier to get off.
Kind of a similar concept as the monster jars with hinges.t