Ideas for Ball only pumper

Talk about ball pumping, stretching, ball enlargement techniques.

Moderator: bigray57

Post Reply
just4me
Posts: 888
Joined: Fri May 06, 2016 7:07 am

Ideas for Ball only pumper

Post by just4me »

I have this idea for a way to use a STJ and silicone ring to just pump balls.
When i try to pump balls only my whole package gets pulled in.
Pumping the whole package is great and I love it and I am just trying
to find a way to isolate balls.

The only thing i can find to do this is a narrow tube that pulls one direction.

I use a STJ with a silicone ring then move to a Monster Sr. ( i would have rather had the junior but this was too goodof a deal to pass up.)
When i get above 15 inches it is work to get out of the ring. At 16 inches i was stuck inside the jar for at least half an hour.
With this in mind... the reason for this is to pump balls only using a smaller hole that is divided in half.

Attached are photos of what I am engineering right now.
These are the templates for what I plan to do when my company leaves.

one pic is all 4 pieces
the next is a pic with two of the pieces assembled
last pic is all 4 pieces assembled.


This is just a paper design.

In terms of measurements:
The opening of the silicone ring gasket is about 2.5 inches.... 6.3 cm

I found a tube i like that is 2 inches across..... 5 cm
That's not a big difference at all but for me it is the different between being sucked in and not being sucked in.

Before I go ahead and transfer these plans onto 3/8 in thick plastic/silicone board....

Does anyone have any thoughts on the diameter of the hole?
or/and
Any other issues i should take into consideration as i continue to refine the mock up?

You can add thoughts in this post or message me.
Thanks Men!
Pump huge!
Attachments
all parts shown and laid out ready to assemble
all parts shown and laid out ready to assemble
bottom half assembled
bottom half assembled
All parts assembled
All parts assembled
User avatar
Doxen
Posts: 51
Joined: Thu Jun 04, 2015 2:45 am
Location: Finland, Helsinki

Re: Ideas for Ball only pumper

Post by Doxen »

Not sure if the measurements are right, but I can see this working well for separating balls for pumping ;)

http://shop.oxballs.com/JUICY-DUO-Pumpe ... X-1349.htm

My regular juicy ring is comfy for pumping my whole package at least :)
just4me
Posts: 888
Joined: Fri May 06, 2016 7:07 am

Re: Ideas for Ball only pumper

Post by just4me »

Thanks for the info.
With what is on this link you can pump either or both? Is that right?

I am trying to make something that comes apart to make it easier to get off.
Kind of a similar concept as the monster jars with hinges.t
Post Reply