Question?
Moderator: bigray57
-
- Posts: 463
- Joined: Wed Jan 12, 2011 12:39 am
- Location: Toronto Ontario
Question?
Can someone tell me the best way to keep mildew/mould from forming on the inside of the clear plastic tubing that connects the pump to the cylinders we pump with? And can you successfully remove the plastic tube from the pump when cleaning it?
- SFBallpumper
- Posts: 1240
- Joined: Wed Nov 01, 2006 5:44 pm
- Location: Riverside, CA
Re: Question?
I just replace my tubing. You can get it at any big hardware store (Lowes, Home Depot, etc.) by the foot. It's cheap--this week I paid around $6 for 25 feet.
The hard part is getting the old tubing off the various connectors, without damaging the connectors. If the tubing has been attached to the connector for awhile, pulling on it to remove it probably won't work. After trying all sorts of methods, I finally came up with a way that will cut through the tubing without cutting into the connectors.
I got a pair of end-cutting pliers (also available from any big hardware store). They cost about $10. The pliers are shown on the left in the first attached photo. I use the pliers to pinch and then cut the tubing, as shown on the right, and in the close-up in the second photo. Note that I'm holding the pliers at slight angle, so that the pliers pinch the tubing end. When held this way, the pliers will make a "V" shaped cut in the tubing. Once you've made the cut, the tubing will pull right off.
The hard part is getting the old tubing off the various connectors, without damaging the connectors. If the tubing has been attached to the connector for awhile, pulling on it to remove it probably won't work. After trying all sorts of methods, I finally came up with a way that will cut through the tubing without cutting into the connectors.
I got a pair of end-cutting pliers (also available from any big hardware store). They cost about $10. The pliers are shown on the left in the first attached photo. I use the pliers to pinch and then cut the tubing, as shown on the right, and in the close-up in the second photo. Note that I'm holding the pliers at slight angle, so that the pliers pinch the tubing end. When held this way, the pliers will make a "V" shaped cut in the tubing. Once you've made the cut, the tubing will pull right off.
It’s the pleasure of the pressure...
-
- Posts: 463
- Joined: Wed Jan 12, 2011 12:39 am
- Location: Toronto Ontario
Re: Question?
Thank you so much for your response, I have sent you a private message…..
- pomp
- Posts: 102
- Joined: Tue Feb 15, 2005 8:07 pm
- Location: Frankfurt, Germany
Re: Question?
hi bigricky,
its very easy to remove plastictubes from connections: heat it up in hot water for 3 minutes than pull it of easily. Pomp
its very easy to remove plastictubes from connections: heat it up in hot water for 3 minutes than pull it of easily. Pomp
-
- Posts: 463
- Joined: Wed Jan 12, 2011 12:39 am
- Location: Toronto Ontario
Re: Question?
wow, thanks for that tip, makes my life easier for sure.
- bignlow
- Posts: 2861
- Joined: Wed Jan 27, 2010 7:30 pm
- Location: Rochdale nr Manchester UK
Re: Question?
Take you're pipe off and soak it in hot water with sterilising fluid as used for babies bottles. I soak my tubes once a month as well.
Bignlow
Bignlow