forums.newart.com

[itwillgetbig]

EASY MADE PUMP

this is very simply ! and works very very well ! and is very very cheap!! to give you an idea of how good it works? 4 full pulls will pull your root! hard!out! LOL LOL !  YOU HAVE BEEN WARNED !

OK.
1. DISASSEMBLE # 5 ? NO DISASSEMBLE # 5  THE PUMP YOU MITE NEED A HAKSAW TO SAW THE PIN TO GET IT OUT OF THE FRAME REMOVE THE NUT ON THE SHAFT TOSS THE FRAME TRASH !
2.WITH A HAMER AND CHISEL OR IF YOU HAVE A VICE YOU NEED TO KNOCK THE CAP OFF.
3.TAKE THE PLUNGER AND CLEAN OFF THE GREASE AND GET A VICE OR VICE GRIPS AND LOCK ON TO THE SHAFT  TO HOLD IT BECAUSE ITS GOING TO GET HOT .
4.NOW TAKE A TORCH AND HEAT THE SHAFT 3 TO 5 INCHES DOWN FROM THE  PLUNGER   PULL THE PLUNGER OFF THE SHAFT TURN IT OVER AND PUT IT BACK ON THE SHAFT HEAT THE END WITH THE TORCH  AND MELT IT IN BUT NOT TO HOT JUST HOT ENOUGH TO MELT IN AND COOL QUICK IF IT IS TO HOT THE PLASIC WILL DRIP YOUL HAVE A BIG HOLE IN THE PLUNGER AND IF THAT HAPPIND EPOXY WORKS GOOD IF YOUR SKILLS ARE BETTER THEN YOUR AVERAGE BEAR THEN THREAD AND TAP THE SHAFT AND PLUNGER.
5.REMOVE THE HOSE UNSCREW THE FITTING NOW I TRIED TO TURN THE VALVE AROUND ON THE PUMP I DID AND IT DIDNT WORK RIGHT SO I USED THE VALVE OFF A BULB ON A BLOOD PRESSURE CUFF AND IT WORKS REALY GOOD PUT IT IN THE A PEICE OF HOSE AND PUT IT IN THE  END PUT GREASE ON THE PLUNGER AND PUT IT BACK TOGETHER PUT A KNOB ON THE END AND A HOSE AND YOUR IN BIZ !